Once they absorb a good impact, you can count on having to put another one on sooner than later.Ī different finger along with your preferred thumbprint has also been helpful The phone is looking for the ideal print, and a finger with any scar in your print won't pick up as well. I dropped mine after putting on aftermarket film and it absorbed the brunt at the edge of the screen. I watched an excessively long YouTube comparing them all. It's not the easily removable thin plastic protecting the pre-installed one. The screen protector IT COMES SHIPPED WITH is very well fit. It might be cut a little different and you place a metal circle where the sensor is for the first full cure If you get it applied exactly as directed. I had my doubts but I figured if it failed it was far cheaper than a replacement screen. I will probably just tear of the protector when it is worn and use the phone without a protector. Unlocks presice and lightning fast each time. Enjoyed it much better without a protector.Ĭurrently using S21 with original protector on it. Using third party protector that was thicker never gave the same performance, often had to press awkwardly harder for it to work, so I removed it. I remember using my S10 with the original screen protector from Samsung. Do not press hard unless your screen protector is too thick and requires you too.īe sure to hold or use the phone as you would normally do during the registration and move and/or change the angle of the thumb a bit for each time getting mostly the center parts first, but then also more towards its sides and tip. Just gently lay the same thumb on the scanner for about a second or two multiple times until it is registered.
0 Comments
Leave a Reply. |